Pacifica
Pacifica Beauty, Reusable Brow Mask,100% Silicone, Vacuum Seal & Lifting Effect
Pacifica Beauty, Reusable Brow Mask,100% Silicone, Vacuum Seal & Lifting Effect
Couldn't load pickup availability
About this item
| Color | Blue |
| Product Benefits | Help to manually smooth out the appearance of fine lines & wrinkles |
| Special Feature | Not Tested On Animals |
| Material Type Free | Mineral Oil Free, Phthalate Free, Petroleum Free, Paraben Free |
| Brand | Pacifica |
Product Description :
- 100% SILICONE MASK creates a vacuum-like seal between your favorite serum and your skin, helping to “seal” in the ingredients and boost hydration
- PERFECTLY STICKY TEXTURE also allow you to gently lift and flatten skin, helping to minimize the appearance of fine lines and wrinkles
- EASY-TO-USE wash, store and reuse over and over – with proper care, these masks should last several uses
- STORAGE TIN comes with breathable tin for easy storage
- FREE OF HARSH CHEMICALS formulated without parabens, phthalates, petroleum, SLS or mineral oil
- 100% VEGAN AND CRUELTY-FREE safe for the planet, animals, and you!
Recharge, reduce, repeat! These high-grade, reusable masks supercharge your skincare by locking in benefits with a vacuum like seal. This next level masking system help to manually smooth out the appearance of fine lines & wrinkles and put your skin on rewind.
Apply a few drops of serum to your skin, pull out lines and place the mask carefully on your skin. Then press down gently, sealing it in place. Leave on for as little time as you’d like or even or sleep in them overnight. Peel them off gently, rinse well with soap and water and let dry before storing in their cute little tin. Take good care of them and they will last for several uses.
From the manufacturer
Important information
Ingredients
100% Silicone
Directions
On clean skin, apply a few drops of your favorite serum to the area to be covered. Be careful to just use a small amount of product. Gently pull skin flat in desired area and apply masks. Add light pressure with your fingers to press them into place. Wait for the desired amount of time (10-20 minutes or overnight if desired!). Remove masks and immediately wash the silicone masks with light soap and water. For best results, let air dry print side down (sticky side up). Return to their tin for storage.
